This test method enables a relative comparison of the predisposition of a spiral wound gasket to inward buckling. The relative resistance to inward buckling of a spiral wound gasket thereby can be determined. This procedure may be used by supplier and user to establish an acceptance/rejection criteria for spiral wound gaskets, when desired.© 2002, 9 pages.
(FSA-MG-502-05) Serrated Metal Gaskets with Covering Layers (SMCL) - Standard for Raised and Flat Faced Flanges per ASME B16.5
This standard provides specifications for the above gasket design as applied to flanges for the pipe sizes included in ASME Standard B16.5. Size, class, construction, materials, marking, as well as dimensions are covered. ©2005, 8 pages.
Click here for a complimentary copy
(FSA-MG-503-06) Serrated Metal Gaskets with Covering Layers (SMCL) - Standard for Raised and Flat Faced Flanges per ASME B16.47
This standard provides specifications for the above gasket design as applied to flanges for the pipe sizes included in ASME Standard B16.47. Size, class, construction, materials, marking, as well as dimensions are covered. ©2006, 16 pages.
Click here for a complimentary copy
(FSA-G-604-07) Oxidation Test Standard for Flexible Graphite Materials
This standard provides two test methods for assessing the relative oxidation resistance of flexible graphite material. Method A is a short duration oven screening test. Method B is a more accurate, longer durating procedure under closely controlled environmental conditions based on Thermogravimetric Analysis (TGA). ©2007, 10 Pages.
Click here for a complimentary copy
(FSA-G-605-11) Standard Test Method for Determining (m) and (y) Loading Constants Applicable to Gasket Materials and Designs
This test method will establish criteria for determining standard loading constants that are referenced in current ASME pressure vessel design. ©2011, 15 Pages.
Click here for a complimentary copy
(FSA-PSJ-701-06) Non-Metallic Expansion Joint Hydrotesting and Vacuum Testing
This specification covers the hydrotesting and/or vacuum testing on non-metallic flanged expansion joints. ©2006, 9 Pages
Click here for a complimentary copy
(FSA-PSJ-702-06) Rubber Flanged Non-Metallic Expansion Joint Installation, Maintenance and Storage
This specification covers the installation, maintenance and storage of non-metallic expansion joints. ©2006, 7 Pages.
Click here for a complimentary copy
(FSA-PSJ-703-11) Guidelines for Elastomers Used in Piping Systems Non-Metallic Expansion Joints
This Standard provides the typical properties of a range of elastomers most frequently used for tube and cover compounds in the manufacture of piping expansion joints. It is an update of Standard FSA-NMJ-703-99,
Specifications of Elastomers Used in Piping Systems Non-Metallic Expansion Joints. Properties listed have shown to provide acceptable performance in applications for which the specific elastomer has been recommended. The Standard is not intended to limit or restrict the use of materials to those listed. Other materials may be developed in the future that will prove to be suitable as well. ©2011, 11 pages.
Click here for a complimentary copy
(FSA-HIPD-801-10) Calculated Leakage Verification Test
This test procedure determines the total amount of gap present between sealing surfaces of a damper.
©2010, 3 Pages
Click here for a complimentary copy
(FSA-HIPD-802-10) Seal Air System Test
This test procedure determines the seal air system performance.
©2010, 3 Pages
Click here for a complimentary copy
(FSA-HIPD-803-10) Industry Process Dampers Terms and Definitions
©2010, 7 Pages
Click here for a complimentary copy
(FSA-HIPD-804-10) Definition of Man-Safe Isolation
©2010, 3 Pages
Click here for a complimentary copy
